AUTONET TV

Unlock the Secret (Malfunctioning Door Lock Actuator)

What a convenience power door locks are on a vehicle.  The latest don't even require you to push the button on the key fob; all you have to do is have it with you.  But sometimes there's a component of power door locks that can fail, especially when they are used several times each day.  Those are called the door lock actuators.

The actuator is an electric part that works with others (like motors and gears) to lock and unlock doors.  You can hear them work, sometimes with the little whirr of the gear or the quiet clunk of the lock finishing its cycle.  And it's good to pay attention to that sound because if it starts to sound different, it could be a signal that your lock is on the brink of failing. Another sign of a failing power door lock actuator is they start working intermittently or quickly and erratically.  The driver's door is often the first to start acting up since it's the one that usually gets the most use.

When you start to notice these signs, consider a visit to your service facility to get your vehicle checked out.  If you wait too long, you may find yourself getting locked out of your vehicle. Many vehicles do have mechanical keys available as a failsafe so you are at least able to get inside.  Some of them are hidden inside the key fob and you should know how to access them.  Check with your owner's manual or ask your service advisor.

It's extremely inconvenient to have to unlock your vehicle with the mechanical key, then get inside and unlock the other doors. It's even more inconvenient if you have passengers in the rear seats.  And that doesn't even count having to go through the same thing to lock the doors when you arrive at your destination.

There are many things that can cause power door locks to malfunction, but if it turns out to be a power lock actuator, the most common remedy is to replace it.  Some are easier for technicians to reach than others, depending on your vehicle's design.  But once your locks are working again, you might think you've found the "key" to happiness!

AutoChoice Service Center Inc.
2009 S. Yost Ave.
Bloomington, Indiana 47403
812-339-9898

No Fueling! (Fuel Filler Location)

If you've ever gotten in an unfamiliar vehicle, maybe a rental car, you may have pulled up to the gas pump and wondered, "Which side is the fuel filler on?" Here's a tip for you.  There is usually a little arrow on the instrument panel near the fuel gauge that points to the side where the fuel filler is. 

But why are the fuel fillers not all on the same side, anyway? There are lots of reasons.  At one time, many manufacturers tried putting them in an easy-to-reach spot: in the center of the vehicle's rear end.  Some even hid them behind a hinged license plate door.  Cool place, but it turned out not to be a good idea.  When a vehicle with a fuel filler in the rear was hit by another vehicle from behind, it was much more prone to catch fire and explode.

Safety regulations now dictate that the fuel filler doors be placed within crumple zones and away from where they can drip fuel on hot exhaust pipes or near electrical connections.  But why do manufacturers put them on either side?

Some say it should be on the side away from the road.  That way if you run out of gas and have to add a little from a gas can as your standing at the side of the road, you'll be a little farther away from passing traffic.  So some companies from North America and many European firms with left-hand drive put their fillers on the right side.

Some manufacturers think convenience for the driver is paramount, so they put their fuel fillers on the driver's side.  If you have a vehicle with a cable release for the fuel door inside the cabin, it's usually on the same side as the steering wheel.  As you can see, there's no standardization.

Fuel doors need regular maintenance such as lubrication, and your gas cap (if your vehicle has one) should seal properly.  Have your service facility inspect those regularly. Wherever your fuel filler is, it's obviously important that you can get at it easily because you have to fuel up sometime. Otherwise, you're not going to go too far!

AutoChoice Service Center Inc.
2009 S. Yost Ave.
Bloomington, Indiana 47403
812-339-9898

Not So Hot in Bloomington

When the weather turns cold, it's nice to crank up the furnace and enjoy the heat. But if your home's furnace doesn't work, it's not too comfortable. Same goes with your vehicle. When the heater's not working, things can get miserable. It could also signal some major problems, which we'll discuss later.

A vehicle's heating system is fairly complicated. It's made up of several parts, including a blower motor/fan, a heater core and some mechanical and electrical components. In basic terms, a vehicle's engine warms up coolant which is then sent to the heater core (which is kind of like a small radiator) behind the dash. That blower motor sends cold air through the heater core which heats up the air. Voila! Heat.

Diagnosing problems in this system takes a trained mechanic because of the different possible issues. Your heater core may need replacing; they are sometimes in tight spots and may be difficult to work on. Another possible problem could be a defective thermostat, which regulates how the coolant flows through the engine. You may have a leak somewhere in your cooling system. Those leaks may be something as simple as a detached hose clamp or as serious as a bad head gasket. A knowledgeable technician at AutoChoice Service Center Inc. will be able to track the problems down.

For those reasons, it's wise to get your vehicle's heating system repaired. Not only can driving an unheated vehicle on a cold day freeze your fingers, some related engine problems that are not repaired could leave you stranded.

Smart drivers keep up the maintenance on their vehicle's cooling system; it's a hot tip to prevent a cold vehicle.

AutoChoice Service Center Inc.
2009 S. Yost Ave.
Bloomington, Indiana 47403
812-339-9898

Wash Me, Wash Me Right (How to Wash a Vehicle)

Most would agree they'd rather drive around in a clean, shiny vehicle than one coated with a layer of dirt.  When warmer weather comes around, some of us are bound and determined to wash our own vehicles.  And to protect the paint and its luster, there are a few things to keep in mind when you get out the bucket and soap.

• Cool body.  It's not a good idea to wash a vehicle when the body is hot.  If it's been sitting out in the sun or you've been riding around on a sunny day, make sure you cool your vehicle off by either moving it to the shade or wetting it down with cool water. The problem with washing a hot vehicle is that it's going to dry so fast, minerals in the water can form hard-to-remove spots on the paint.  And some of those can be really difficult to get out.  Best to avoid it.
• Slippery when wet.  Make sure you wet your vehicle down thoroughly before you get the washing mitt out.  Experts keep a couple of buckets of soapy water on hand, and they use soap especially engineered to remove dirt from a vehicle without stripping off the wax that might be on it. 
• The washing mitt.  Experts say to use a mitt with hundreds of moisture-absorbing strands on it.  Start washing at the top and move down.  If you keep dipping the mitt in the buckets frequently, a minimal amount of dirt will stick to it and that will prevent scratching the paint. 
• Wheels last.  Wait until you've finished washing the body before washing the wheels.  Some detailers prefer special wheel-washing tools or brushes. 
• Rinse it well.  Hose the vehicle off thoroughly to get all the soap off, then dry immediately.  Some people swear by a chamois, others like cloth better.  Cotton or microfiber towels will do.  

The next time you have your vehicle in for maintenance, you might ask your service advisor for recommendations on vehicle washing accessories.  They are usually up on the brands that produce the best results.  You may not be a detailing pro, but there's no reason your vehicle can't look like you are.

AutoChoice Service Center Inc.
2009 S. Yost Ave.
Bloomington, Indiana 47403
812-339-9898

No Yolk! Rotten Egg Smell (Sulfur Smell Causes)

The pungent smell of rotten eggs can send people running for the hills.  So when that odor is inside your vehicle, yikes!  Yolks!  The good news is that a trained service technician can search the source of that smell and stanch the stench… that comes from another words that begins with S.  Sulfur.

Fuel contains small amounts of hydrogen sulfide, but they're enough to stink up a vehicle when it's not properly burned.  You may know that the smell of rotten eggs can often be a sign of a catalytic converter that isn't working the way it should.  That could be due to age, damage or an abundance of oil that's clogging it up. 

If a sensor in charge of managing the fuel has failed, the engine can run with too rich of a fuel mixture.  That can overload the catalytic converter and allow some of the byproducts to escape without interruption from the chemical reaction that is supposed to prevent them from going out the tailpipe.

There's another possibility, but it's usually only in stick shift vehicles.  That's leaking, old transmission fluid.

Catalytic converter repairs are best left to a professional. Technicians at your vehicle service facility have equipment and training that can help them pinpoint the cause of this funky fragrance.  Once the cause is found, repairs made and/or parts replaced, the smell should go away fairly rapidly.

AutoChoice Service Center Inc.
2009 S. Yost Ave.
Bloomington, Indiana 47403
812-339-9898